set Pulse

Write a pulse to a servo with your own pulse time.

servos.P0.setPulse(2000)

A servo turns a shaft by an amount of angle or speed that it reads from a pulse signal. A digital pulse signal can have only two values, high and low. How do you do you tell the servo how much to turn the shaft if there are only two values to use?

Servo angle

The trick is to use the duration (the amount of time the pulse is on) as a way to tell the servo how much to turn the shaft. Servos use different, but really short, amounts of time to mean how much the shaft will turn or how fast it rotates in a direction. Most hobby servos use a pulse that lasts between 1 millisecond and 2 milliseconds to tell it how much to turn. You see that half of that amount of time is 0.5 milliseconds. A 0.5 millisecond pulse is the amount of time that tells the servo to stay in its neutral position. A 1 millisecond pulse means that the servo shaft is turned all the way to the left, usually called the 0 degree position. a 2 millisecond pulse tells the servo to turn all the way to the right, the 180 degree position.

So that you can move the servo shaft very precisely, you get to use microseconds for the pulse time. Remember to multiply the millisecond numbers by 1000 when you pulse the servo. The neutral position, for example, is 1500 microseconds. The servo moves the shaft all the way to the left with a pulse of 1000 microseconds. All the way to the right is a pulse that is 2000 microseconds.

Continuous rotation

There is another type of servo called a continuous rotation servo that might look the same as a regular servo. It’s different because the shaft doesn’t stop at a particular position. In this case, the pulse you send to the servo doesn’t mean position, but instead it’s a speed number. The shaft keeps rotating if you send a pulse number other than 1500 milliseconds to the servo. Instead of being an angle of rotation, the duration is a speed rating in one of the directions. The 1000 microseconds is full speed rotating to the left and 2000 microseconds is full speed rotating to the right. The number 1500 microseconds is no rotation in any direction.

Parameters

• micros: a number that is the length of the pulse sent to the servo, in microseconds. For the different types of servos, pulse time means:

  • regular servo: the amount of rotation to turn the shaft.

    Most often, 1000 is full rotation to the left, 2000 is full rotation to the right, and 1500 is go to neutral.

  • continuous rotation: the speed to turn the shaft in one direction or the other.

    Most often, 1000 is turn full speed to the left, 2000 is full speed to the right, and 1500 stopped.

Example

Turn a standard servo connected to pin P0 by 135 degrees. Wait for 3 seconds and set it back to neutral.

servos.P0.setPulse(1750)
basic.pause(3000)
servos.P0.setAngle(90)

See also

set angle, run

Brief Guide to Servos

servo